Ledi Scout Micro Water Maker

Scout Micro is the simplest watermaker we could make by design.

We stripped away every non essential feature to deliver the smallest, simplest, and most versatile watermaker in the LEDI range. No complexity. No fluff. Just reliable desalination in the most compact form we can build.

At only 55 x 33 x 12 cm, Scout Micro mounts on any vertical or horizontal surface and fits where full size systems do not. It is ideal for small vessels, tight engine bays, off grid setups, and emergency water readiness.

Scout Micro is paired with a 12V brushless centrifugal feed pump that is ultra quiet, highly efficient, and fully submersible. If you do not want a permanent installation, you do not need one. Drop the pump over the side, hit go, and start making water.

Output is around 10 litres per hour, with a built in upgrade path to 20 LPH as your needs grow. LEDI can supply all components required to upgrade the system later, so you can start small and scale without replacing the unit.

Scout Micro does not include pressure relief valves, UV sterilisers, sea strainers, or automation features found on the Scout. That is intentional. This system is built to be simple, rugged, serviceable, and affordable. Fewer parts mean fewer failure points and complete user control.

Same fundamentals. Fewer parts. Less to break.

Scout Micro is watermaking reduced to what matters.

Specifications
Output: 10 litres per hour nominal
Upgrade capacity; Upgradeable to 20 LPH with LEDI supplied components
Operating voltage: 12V DC nominal
Operating range 10.5 to 14.4V DC
Power consumption: Main module: 12V DC, 13.5A
Feed pump: 12V DC, 3A
Total system current draw: Approximately 16.5A at 12V DC
Power Lead: 1m lead to Anderson plug
High pressure pump: Pumptec 107SS stainless steel plunger pump
Feed pump:12V brushless DC centrifugal pump
PPS and carbon fibre construction:Installed or submersible
Not self priming. Must be mounted below the waterline or submerged
Recovery ratio: Approximately 15 percent
Pre filtration: 2.5 x 5 inch sediment filter housing                                                                   5 um pleated filter
Membrane: WSD 2514 seawater reverse osmosis membrane
Product water quality: Typical permeate less than 500 ppm TDS
Maximum operating pressure: Up to 1000 PSI                                                                Salinity rating: Designed for seawater up to 35,000 to 40,000 ppm TDS                    Operating temperature range: Feed water: 5 to 35°C
Electronics: 0 to 40°C
Mounting orientation: Vertical or horizontal
Dimensions: 55 x 33 x 12 cm
Weight: 14 kg